Ship toilet SANIMARIN 35 ST COMFORT , SFA (France)

Ship toilet  SANIMARIN 35 ST COMFORT

SANIMARIN ® 35 ST COMFORT : the straight model SANIMARIN ® 35 COMFORT is the ideal solution for  mounting  at a vertical partition.

Modern design and light weight make it possible to find a place for this toilet on any type of vessel.

A combined model with a bidet is offered.

Electronic control panel
To simplify operation, all control functions of the automatic toilet are combined in the new Sanimarin remote control. In particular, two flush cycles are possible: "Eco-friendly" (1.2 l) and "Standard" (2.2 l with the possibility of increasing the volume to 3 l), as well as a faecal tank full indicator and a button for emptying the toilet bowl when the sea is rough.

TECHNICAL DATA
Water consumption

• ECO 1.2l< /li>
• NORMAL 2,2l

Horizontal waste disposal

• ECO 30 m
< li>NORMAL 30 m
• EMPTY 30 m

Power consumption
ECO cycle (10 s)
12V : 0.070 Ah
24V : 0.042 Ah
NORMAL cycle (19 sec)
12V : 0.132 Ah
24V : 0.079 Ah
Electrical shutdown (per second)   ;                       
12V : 0.007Ah
24V : 0.004Ah
Attention: During normal daily use by four users, the electricity consumption of a SANIMARIN toilet is less than 1% of the total electricity consumption on the ship .
Minimum water pressure for flushing 1.7 bar
Total time

• ECO 10 s
• NORMAL 19 s

Used drain height

• ECO 3 m
• NORMAL 3 m
• EMPTY 3 m

Power consumption
12 V (300 W) 25 A
24 V (360 W) 15 A
Weight  21.2 kg

OPERATING PRINCIPLE
Control SANIMARIN ® 35 ST COMFORT  is carried out using the electronic keyboard  with the following built-in functions:
• NORMAL cycle ("standard cycle"): press the "NORMAL" button located on the control panel. The duration of the cycle is 19 seconds. Water consumption - 2.2 liters.
• ECO cycle (“economy cycle”): press the “ECO” button on the control panel. The duration of the cycle is 10 seconds. The water consumption is 1.2 liters.
• VIDAGE cycle (“draining”): on the control panel, hold down the “EMPTY” (“Cleaning”) button.

Setting the flush cycle
You can change the duration of the NORMAL cycle and extend its duration by 5 additional seconds. Thus, the duration of this cycle can be from 19 to 24 seconds, and the water consumption can be from 2.2 to 3 liters.

OPERATION
SANIMARIN ® 35 ST COMFORT is no different from a regular toilet. It does not require additional maintenance.
Attention: The SANIMARIN ® 35 ST COMFORT toilet must only be used for dissolving and pumping out faecal matter and toilet paper. The warranty does not cover any equipment failure caused by crushing foreign objects such as fabrics, panty liners, sanitary napkins, condoms, hair, or pumping liquids such as solvents or oils. or in case of a long break in operation SANIMARIN ® 35 ST COMFORT, turn off the water supply and turn off the power supply.

DRESS WATER
Attention: in In any case, the installation must comply with current legislation on emissions into the marine environment. The  SANIMARIN®  station provides only crushing and pumping without the use of disinfectants.
Attention: for equipment installed below the waterline, it is necessary to bring the pipeline to a level higher than the water level by 50 cm. Install an anti-vacuum valve at the highest point of the pipeline, then gradually lower it down.

TESTING AND COMMISSIONING
Turn on the equipment, fully open the water supply valve for proper water flow .
NORMAL mode
• Press the NORMAL button. After 9 seconds of water supply, wait another 6 seconds of engine operation.
Provide an additional drain of water for 4 seconds. Add a few pieces of toilet paper to the water. Carry out the above operations.
ECO mode
• Press the ECO button. After 3 seconds of water supply, wait another 3 seconds of engine operation.
Allow an additional 4 seconds of flushing.

CLEANING / REMOVING
To clean the toilet, use standard cleaning products.

PRESERVATION
In the event of a long break in use SANIMARIN ® 35 ST COMFORT flush the toilet bowl with fresh water and press "EMPTY" water drain button.

PERIODIC MAINTENANCE
In most cases, the causes of crusher failures are minor malfunctions. You can repair the equipment yourself. To facilitate the search for the cause of the malfunction and its elimination, the instructions provide a list of the main malfunctions and ways to eliminate them. For other faults, please contact SFA Customer Service or the appropriate SFA Repair Service.

WARRANTY CONDITIONS
The warranty period for the unit is two years from the date of purchase, provided it has been used correctly. installation and operation: extract only faecal matter and toilet paper. The warranty covers the replacement or repair in our technical workshops of spare parts found to be defective. In any case, the warranty does not include the possibility of compensation and damages.
The warranty does not cover port costs and packaging costs,  transport costs. In addition, the warranty does not cover the replacement or repair of parts that fail due to normal wear and tear, damage to the equipment due to misuse, lack of maintenance, or other causes beyond our control. The warranty is immediately void if the customer makes changes to the design of the product or repairs to the delivered product without prior agreement with the manufacturer. Repair, modification or replacement of spare parts does not extend the warranty period for the product.
However, in the event that we are held liable for damage caused, the amount of compensation for damage will be limited to the cost of the equipment supplied and the cost of its installation. The warranty is effective from the date of purchase indicated on the seller's receipt. Upon the occurrence of warranty conditions, the customer is obliged to present a receipt, and in the absence of a receipt, the warranty period is established from the date of manufacture of the product.

Ship toilet SANIMARIN 35 ST COMFORT , SFA (France)